User manual Countryman Type 10S Stereo Direct Box DT10S
Operating instructions and pdf manual for use - Countryman Type 10S Stereo Direct Box DT10S User manual, User manual Countryman Type 10S Stereo Direct Box DT10S, Countryman, Type, 10S, Stereo, Direct, Box, DT10S, Video
User manual for Countryman Type 10S Stereo Direct Box DT10S
Manufacturer: Countryman
Basic description and contents of package
Product classification: Pro Audio - Recording - Direct Boxes
Safety instructions
Startup and operation of the direct boxes
Tips for setting up your Countryman
Settings and expert assistance
Contact Countryman service
Troubleshooting
Warranty information
Price: 366 USD
We recommend checking out our discussion threads on the Countryman Type 10S Stereo Direct Box DT10S,
which address similar problems with connecting and setting up Direct Boxes Countryman.
User manual for the Countryman Type 10S Stereo Direct Box DT10S
The user manual for the Countryman Type 10S Stereo Direct Box DT10S provides
necessary instructions for the proper use of the product Pro Audio - Recording - Direct Boxes.
The Countryman Type 10S Stereo Direct Box can be used to connect the output of any high impedance instrument, such as a keyboard or guitar, to a balanced XLR microphone input, allowing you to send signal to a mixer or mic preamp from your high impedance instrument. It features a 1/4" and RCA input per channel, as well as a gold-plated stereo 1/8" input. The unit also has two 1/4" throughputs, allowing you to run a high impedance signal to an amplifier. The two balanced XLR outputs allow you to run your signal to any standard mic level input.
The Type 10S is designed with a flat frequency response from 10Hz to 50kHz with a linear phase response within two degrees for its range. This provides an accurate transient response, resulting in a transfer of your signal that is faithful to the source. The Type 10S features an active circuit, powered by 48 volt phantom power or an internal nine-volt battery. The active circuit allows your signal to pass through the direct box without being padded, as with passive boxes, and results in lowered noise and interference.
The unit features two channel independent ground lifts, which can reduce hum and electrical interference. The Type 10S also has a 0dB, 15dB, or 30dB selectable pad per channel, as well as a phantom and battery power test switch.
If you own a Countryman direct boxes and have a user manual in electronic form,
you can upload it to this website using the link on the right side of the screen.
You can upload and download the manual for the Countryman Type 10S Stereo Direct Box DT10S in the following formats:
*.pdf, *.doc, *.txt, *.jpg - Other formats are unfortunately not supported.
Additional parameters of the Countryman Type 10S Stereo Direct Box DT10S:
Specifications
Input Connections
2x metal threaded nose 1/4" (6.35 mm) 2x gold plated RCA 1x gold plated stereo 1/8" (3.18 mm)
Throughput
2x 1/4" (6.35 mm)
Output Connectors
2x XLR
Frequency Response
10 Hz to 50 kHz (+/- 1 dB)
Deviation from Linear Phase
2° (30 Hz) 0° (100 Hz to 20 kHz)
Input Level
5 Vpp (0 dB pad @ 1% THD) 28 Vpp (-15 dB pad @ 1% THD) 158 Vpp (-30 dB pad @ 1% THD)
Input Protection
220 Vrms and 20 kV discharges
Transformer Isolation Voltage
>500 V from instrument ground to either XLR output pin 1
Input Resistance
10 MΩ (0 dB pad) 10 kΩ (-15, -30 dB pad) 20 kΩ (RCA and 1/8" inputs)
Input Capacitance
240 pF (equal to 3 ft of low-capacitance guitar cable)
Output Polarity
Pin 2 positive
Pad
0 dB, -15 dB, -30 dB
RF Low-Pass Filtering
Input: 1.5 MHz Output: 60 kHz
Cross-Talk Rejection
>105 dB (20 Hz to 20 kHz)
Controls
2x Ground lift switch 2x Pad selector switch 1x Power test switch
Noise
1.8 μVrms (-115 dBVrms with shorted input, bandwidth = 22 Hz to 20 kHz)
Distortion
1 Vpp in, RL = 1.2 kΩ through 200' of XLR cable: THD: < 0.001% at 1 kHz < 0.005% from 30 Hz to 20 kHz IMD: < 0.002% (10 kHz/60 Hz, 4:1)
Power Requirement
48 V Phantom @ 1.5 mA or 9 V Battery @ 4.8 mA (130 hours on a typical alkaline)
The user manual for the Countryman Type 10S Stereo Direct Box DT10S can be downloaded in .pdf
format if it did not come with your new direct boxes, although the seller is
required to supply one. It is also quite common that customers throw out
the user manual with the box, or put the CD away somewhere and then can’t find it.
That’s why we and other Countryman users keep a unique electronic library
for Countryman direct boxess,
where you can use our link to download the user manual for the Countryman Type 10S Stereo Direct Box DT10S.
The user manual lists all of the functions of the Countryman Type 10S Stereo Direct Box DT10S,
all the basic and advanced features and tells you how to use the direct boxes.
The manual also provides troubleshooting for common problems. Even greater
detail is provided by the service manual, which is not typically shipped with the product,
but which can often be downloaded from Countryman service.
If you want to help expand our database, you can upload a link to this website
to download a user manual or service manual, ideally in .pdf format. These pages
are created by you – users of the Countryman Type 10S Stereo Direct Box DT10S. User manuals are also
available on the Countryman website under Pro Audio - Recording - Direct Boxes.
Question and answer discussion forum concerning user instructions and resolving problems with the Countryman Type 10S Stereo Direct Box DT10S - no comments have been made yet - be the first to add a comment
Question and answer discussion forum concerning user instructions and resolving problems with the Countryman Type 10S Stereo Direct Box DT10S - no comments have been made yet - be the first to add a comment