| Keyboard | 37-note (slim-key, no velocity sensitivity, no aftertouch) |
| Polyphony | Maximum Polyphony: 2 voices for duophonic; normally monophonic |
| Controllers | Transpose Positions: 2 octaves down, normal, 2 octaves up
Proportional Pitch Control
Pitch Down Pad (b): about -2 / 3 octave
Modulation Pad (-)
Pitch Up Pad (#): about +2 / 3 octave |
| Noise Generator | Noise Spectrum Types: White and pink |
| Portamento | Maximum Speed: About 0.01 ms/oct
Minimum Speed: About 1.5 seconds/oct |
| VCO | Voltage-Controlled Oscillator
Waveforms: Sawtooth, square, pulse (dynamic pulse)
Frequency Range:
VCO-1 in Low Frequency Mode: 0.2 to 20 Hz
VCO-1 and VCO-2 (Audio Range): About 20 Hz to 20 kHz
Warm Up Drift: 1/30 semitone from turn on max
Pulse Width: 50 to 5%
Pulse Width Modulation:
ADSR: +45%
LFO: +15%
Voltage Controlled Response: 1 V/oct
Maximum Frequency Shifts:
LFO Sine Wave: +1/2 oct.
LFO Square Wave: +1.5 oct.
ADSR: +9 oct.
S/H: +2 oct.
(*VCO-1 is low note priority, VCO-2 is high note priority) |
| VCF | Voltage Controlled Filter
Types: Low pass (I: 12 dB/oct., II III: 24 dB/oct.)
Frequency Range: 16 Hz to 16 kHz
Maximum Usable Q: 30
Resonance: 1/2 - self oscillate
Voltage Controlled Response:
C3 key (left edge) 0 V
C6 key (right edge) 3 V |
| VCA | Voltage Controlled Amplifier
Dynamic Range: 80 dB |
| Ring Modulator | Type: Digital
Input Signal: VCO-1, VCO-2 (square wave) |
| Sample & Hold | Command Sources: Keyboard or LFO trigger
Sampled Signals:
VCO-1 sawtooth wave and square wave
VCO-2 square wave and pink noise |
| Envelope Generators | ADSR Envelope Generator
Attack Time: 5 msec. to 5 sec.
Decay Time: 10 msec. to 8 sec.
Sustain Level: 0 to 100% or Peak
Release Time: 15 ms to 10 seconds
AR Envelope Generator
Attack Time: 5 ms to 5 seconds
Release Time: 10 ms to 8 seconds |
| Control Input | Control Input Jacks
Pedal: 1/4" / 6.3 mm monaural phone jack
Portamento Foot Switch: 1/4" / 6.3 mm monaural phone jack |
| Audio Output | Low
Connector: 1/4" / 6.3 mm monaural phone jack
Maximum Output Level: -20 dBu @ 10 kOhms load
Output Impedance: 10 kOhms
High
Connector: XLR connector
Maximum Output Level: +4 dBu @ 1 kOhm load
Output Impedance: 330 ohms
Headphones
Connector: 1/4" / 6.3 mm stereo phone jack
Maximum Output Level: 50 mW + 50 mW @ 33 ohms load
Output Impedance: 10 ohms
(Controllable by volume knob) |
| External Analog Audio Input | Connector: 1/4" / 6.3 mm monaural phone jack
Maximum Input Level: -10 dBu
Input Impedance: 22 kOhms |
| MIDI | In |
| USB | Type B |
| CV In/Out Controls | Keyboard CV (In/Out): 1 V/octave
Connector: 1/8" / 3.5 mm monaural phone jack |
| Gate | Gate In: +3 V (minimum)
Gate Out: +10 V, key down; 0 V all keys up
Connector: 1/8" / 3.5 mm monaural phone jack |
| TRIG Connector | Trig In: +3 V pulse min., 10 μsec duration minimum
Trig Out: +10 V pulse on key depression, 10 μsec duration
Connector: 1/8" / 3.5 mm monaural phone jack |
| Power | Power Supply: AC adapter jack (9 VDC)
Power Consumption: 6.5 W |
| Dimensions (W x D x H) | 19.8 x 15.0 x 4.7" / 50.2 x 38.0 x 12.0 cm |
| Weight | 11.0 lb / 5.0 kg |
Question and answer discussion forum concerning user instructions and resolving problems with the Korg ARP Odyssey Analog Synthesizer ODYSSEY - no comments have been made yet - be the first to add a comment